GENERAL INFORMATION

This product is not recommended for use in pure oxygen

and/or oxygen rich systems and should not be selected as

a sealant for chlorine or other strong oxidizing materials.

For safe handling information on this product, consult the

Material Safety Data Sheet (MSDS).

Directions for use

1. For best performance bond surfaces should be clean and

free from grease.

2. Moisture curing begins immediately after the product is

exposed to the atmosphere, therefore parts to be

assembled should be mated within a few minutes after the

product is dispensed.

3. When joint is assembled pressure should be applied to

spread the adhesive out and fill the joint completely.

4. The bond should be allowed to cure 24 hours before

subjecting to heavy service loads.

Not for product specifications

The technical data contained herein are intended as reference

only. Please contact your local quality department for

assistance and recommendations on specifications for this

product.

Storage

Store product in the unopened container in a dry location.

Storage information may be indicated on the product container

labeling.

Optimal Storage: 8 °C to 21 °C. Storage below 8 °C or

greater than 28 °C can adversely affect product properties.

Material removed from containers may be contaminated during

use. Do not return product to the original container. Henkel

Corporation cannot assume responsibility for product which

has been contaminated or stored under conditions other than

those previously indicated. If additional information is required,

please contact your local Technical Service Center or

Customer Service Representative.