General Appearance

Britemor 4455 is a clear, mobile yellow-green liquid in daylight and appears brilliant yellow under

UVA light of 365 nm peak wavelength (black light).

General Composition

Britemor 4455 is a stable solution of solvents, non-ionic emulsifying agents and fluorescent dyes. It

contains no added sulphur, halogen or inorganic compounds and is essentially ash free on ignition.

Temperature Stability

Britemor 4455 remains stable without precipitation or separation and has good resistance to heat

fade if subjected to prolonged or excessively high temperatures during processing.

Britemor 4455 is typically used for the inspection of precision castings and forgings, machined

surface and fabrications.

Sensitivity Level

Britemor 4455 is approved to AMS 2644, Type 1, Method A & C, Level 2.

Typical Properties

Flash Point : > 100°C (212°F), method: ASTM D 93

Viscosity at 40°C : approx. 8 mm2/s

Density at 20°

C : approx. 0.9 g/cm3

Water Solubility : practically insoluble

Surface Preparation

The successful application of penetrant is completely dependent on the ability of the penetrant to

enter a defect which is open to the surface. All paint, organic coatings, oils, greases, carbon

deposits, rust, scale, flux residues and any other contaminants must be removed completely before

application of the penetrant. When aqueous cleaners are used, it is essential that the component is

thoroughly dried before penetrant application, as water entrapment could reduce the probability of

defect detection.

Application of Penetrant

Methods which can be used include immersion, flow-on, electrostatic, aerosol or conventional

spray, brush-on and wipe-on. In the case of immersion, it is bad practice to drain on to a drip tray

which allows the penetrant to run back into the tank. It is also important to ensure that the penetrant

is allowed to drain from areas of entrapment caused by the geometry of the component. Ideal

processing temperatures for normal use of penetrant lie between 10 - 35°C (50 - 95°F).