下載次數(shù)：207次 瀏覽次數(shù)：202次發(fā)布時間：2015-10-15 16:36OPERATION:
? Connect the supplied 12
VDC power adapter to the
meter and to the mains line.
? Connect the ORP electrode
to the BNC socket on the
bottom of the meter.
? Always remove the elec-
trode protective cap before
taking any measurement. If
the electrode has been left
dry, soak the tip (bottom 2.5
cm) in rinse solution
(M10000B) for a few minutes to reactivate it.
? Turn the instrument on by pressing the ON/OFF key.
? Allow the reading to stabilize and the meter will start continuous monitoring.
? The meter is factory calibrated.
? A blinking alarm will indicate when the measured ORP value is lower or higher than the setpoint, depending on user selection.
 |  |  |
